Graesholt wrote: ↑Fri Jun 24, 2022 4:52 pm...If you will provide a syntax example, I can try command line...
Assuming you did ALL required steps in initial post by daemon, where the tool and files are, at the top in the address bar of the windows explorer,
(not where the search bar is on the right) type "cmd" and hit enter on the keyboard, the cmd window will open and type the following
Code: Select all
for %G in (*.raw) do 1886_maps.exe "%G"
The process should start immediately, if steps are NOT performed correct from beginning this way you'll see actual error displayed.
Or you can make an empty text file, paste inside:
Code: Select all
for %%G in (*.raw) do 1886_maps.exe "%%G"
pause
this time the "%" is doubled, change extension from .txt to .bat then run that bat file by double clicking on it like you would any executable.
either way you choose to run it the result will be identical.
That way you'll know what is going on.
And as daemon said, you probably tried the process on a wrong file, so make sure you pay close attention on what your doing, every step.