Page 1 of 1

Elite Dangerous 3D model extraction (Guide coming soon)

Posted: Mon May 04, 2015 6:33 am
by eriger777
I've figured it out finally. (This is using a ripper method)

Image

Re: Elite Dangerous 3D model extraction (Guide coming soon)

Posted: Tue May 05, 2015 7:12 pm
by prefim
Can't wait for this! details please!!!

Re: Elite Dangerous 3D model extraction (Guide coming soon)

Posted: Sat May 09, 2015 4:43 pm
by zookone
Bump for details....

Re: Elite Dangerous 3D model extraction (Guide coming soon)

Posted: Tue May 12, 2015 7:52 pm
by eriger777
This method uses ninjaripper. I've found out how to hook to it properly. I just hope that one day someone will make a proper converter.

Re: Elite Dangerous 3D model extraction (Guide coming soon)

Posted: Tue May 12, 2015 11:17 pm
by zookone
I was struggling to get it hooked, I couldn't figure out how to get past the launcher. If you have any tips or can post a screenshot of your Ninja settings it would be awesome!

Re: Elite Dangerous 3D model extraction (Guide coming soon)

Posted: Thu May 14, 2015 8:08 am
by prefim
I found i had to have ninja ripper running and have already set the game location and rip directory first (and tried to run the game from it - at which point it crashes).

This seems to store the last settings so when you run auto injector, you should see injection sucessful when the game loads.

its still not ripping correctly from what I can tell (pinged OP a message on reddit where its gaining traction).

hoping the in game rips look as good as the viper rip he's done.